Flying-Probe PCB Tester

Overview

A bed-of-nails alternative: probes on a CoreXY motion system measuring impedance point-to-point, so a bare board gets tested without machining a custom fixture for it.

Add the fuller story here — the problem it solves, why you took it on, and the one-line pitch you'd give at a poster session.

How it works / the build

Describe the design: architecture, key components, the approach. Drop in schematics or diagrams. Real numbers welcome.

Results & measurements

What did you measure? Add plots, tables, or the headline figures — the honest ones, including anything that didn't hit spec.

Challenges & what's next

What fought back, what you learned, and where this goes next.

Gallery